• CHECK TO MAKE SURE CONDENSER IS LEVEL     
  
• REMOVE DIRT, DEBRIS, LEAVES   
  
• CLEAN ELECTRICAL COMPONENTS   
  
• CLEAR DRAINAGE HOLES                                   
  
• CHECK FAN MOUNTING BRACKET 
  
• CHECK & RECORD FAN AMP DRAW
  
• CHECK FOR BEARING WEAR ON FAN MOTOR
  
• CHECK & RECORD COIL TEMPERATURE DIFFERENTIAL
  
• CHECK SUCTION LINE INSULATION
  
• TIGHTEN & SECURE ALL ELECTRICAL CONNECTIONS
  
• CHECK FOR FRAYED OR WORN WIRING
  
• CHECK VOLTAGE & RECORD
  
• CHECK DISCONNECT 
  
• CHECK FUSES AND HOLDERS

• VERIFY CAPACITOR MICROFARAD RATING 
  
• CHECK CRANKCASE HEATER OPERATION
  
• CHECK ELECTRICAL RELAYS
  
• CHECK HIGH & LOW PRESSURE CONTROLS
  
• CHECK & RECORD SUPERHEAT
  
• CHECK & RECORD COMPRESSOR AMP DRAW
  
• CHECK HIGH TEMPERATURE DIFFERENTIAL ACROSS REFRIGERATION COMPONENTS
  
• CHECK & RECORD OPERATING TEMPERATURES AND PRESSURES
  
• CHECK ADEQUATE REFRIGERANT CHARGE
  
• CHECK TO MAKE SURE REFRIGERANT PIPING IS SECURE AND NOT VIBRATING
  
• CHECK FOR AND REPLACE MISSING SCREWS, BOLTS AND HARDWARE

EVAPORATOR 

• CLEAN EVAPORATOR COIL (ONCE A YR. 1ST VISIT)
  
• CHECK FOR AIR RESTRICTION
  
• CHECK TXV FOR LOCATION & CONTACT WITH SUCTION LINE
• CHECK & SECURE SUCTION LINE INSULATION
  
• CHECK CAPILLARY TUBING FOR KINKS
  
• CHECK & CLEAN THE CONDENSATE PAN
  
• CHECK & CLEAR THE CONDENSATE TRAP AND PIPING
  
• CHECK OPERATION OF THE CONDENSATE PUMP & SAFETY SWITCH

FURNACE, AIR HANDLER, CONTROLS

• CHECK THE BLOWER ASSEMBLY
  
• CHECK THE AIR FILTER (WILL REPLACE IF CUSTOMER HAS ONE AVAILABLE OR ASKS US TO BRING ONE)
  
• CLEAN THE INSIDE COMPARTMENT
  
• CHECK BLOWER MOTOR, LUBRICATE IF NEEDED
  
• CHECK & RECORD BLOWER MOTOR AMP DRAW
  
• CHECK BLOWER BELT & TENSION
  
• CHECK FAN CENTER & COOLING RELAY
  
• CLEAN THE EXTERIOR OF THE UNIT
  
• TIGHTEN & SECURE UNIT ELECTRICAL CONNECTIONS 
  
• CHECK FOR FRAYED OR WORN WIRING
  
• CHECK & RECORD TEMPERATURE DROP ACROSS THE EVAPORATOR COIL
  
• CHECK FOR & REPLACE MISSING SCREWS AND BOLTS
  
• CHECK THERMOSTAT ELECTRICAL CONNECTIONS
  
• RELEVEL THERMOSTAT IF NECESSARY
  
• CHECK THERMOSTAT ACCURACY

DUCTWORK

• VERIFY THAT ALL REGISTERS ARE OPEN
  
• CHECK FOR PROPER AIRFLOW
  
• VERIFY PROPER DUCT SIZE
  
• CHECK DUCTWORK FOR AIR LEAKAGE
  
• CHECK FOR ANY MISSING OR LOOSE INSULATION

BENEFITS

• MAINTAINS EFFECIENCY
  
• EXTENDS THE LIFE OF EQUIPMENT
  
• PEACE OF MIND

MEMBERSHIP ALSO INCLUDES:

• 10% OFF SERVICE CALLS FOR THE YEAR
  
• 10% OFF PARTS FOR THE YEAR
  
• PRIORITY RESPONSE ON SERVICE CALLS